Kawasaki STX-15F Jet Ski User Manual


 
FUEL SYSTEM (DFI) 3-49
Fuel Injectors (Service Code/Character-41, 42, 43, 44/InJ1, InJ2, InJ3, InJ4)
Remove connectors for injector [A].
Connect each test light set [B] to the injector harness con-
nector [C].
Turn the i gnition switch ON.
While cranking the engine with the starter motor, watch
the test lights.
If the test lights flicker at regular intervals, the injector
circuit in the ECU, and the wiring are good. Perform the
“Injector Resistance Inspection”.
Injector signals can be also confirmed by connecting the
hand tester 10 V AC) instead of the test light set to
the injector harness (female) connector. Crank the en-
gine with the starter motor, and check to see if the hand
oscillates at regular intervals.
Special Tool - Hand Tester: 57001-1394
If the test light doesn’t flicker (or the test hand doesn’t
oscillates), check the wiring and connectors again. If the
wiring is good, check the injector voltage.
Injector Resistance Inspection
Removethedeliverypipeassembly.
Disconnect the connector from the injector [A].
Measure the injector resistance with the hand tester [B].
Special Tool - Hand Tester: 57001-1394
Injector Resistance
Standard: about 11.7 12.3 @20°C (68°F)
If the reading is out of the range, perform the “Injector Unit
Test”.
If the reading is normal, perform the “Injector Unit Test”
for confirmation.
Injector Unit Test
Use two leads [A] and the same test light set [B] as in
“Injector Signal Test”.
Rating of Bulb [C]: 12 V, 3 3.4 W
12 V Battery [D]
CAUTION
Be sure to connect the bulb in series. The bulb
works as a current limiter to protect the solenoid
in the injector from excessive current.
Connect the test light set to the injector [E] as shown.
Open and connect [F] the end of the lead to the battery
(–) terminal repeatedly. The injector should click.
If the injector does not click, replace the injector.