Filter
Top Products
13-12 H ULL/ENGINE HOOD
Fittings
•
Pull out the holder [A].
•
Unscrew the mounting bolts [D] and remove the cable
bracket [C] with the cable [B].
•
To remove the right side cover, pull the holder [A] off the
cable bracket.
•
Unscrew the mounting nuts [A] and washers [B] and the
left [C] and right [D] covers.
•
Unscrew the crossmember bolts [E] and bracket [F], and
remove the crossmember [G].
Crossmember Installation
•
Apply a non-permanent locking agent to the crossmem-
ber bolts and torque them.
Torque - Crossmember Bolts: 7.8 N·m (0.80 kgf·m, 69 in·lb)
•
Be sure that the dampers [A] are in position.
•
Apply a non-permanent locking agent to the cable bracket
mounting bolts and tighten them securely.