Kawasaki STX-15F Jet Ski User Manual


 
ELECTRICAL SYSTEM 14-51
Kawasaki Smart Steering System
Steering Position Sensor Input Voltage Inspection
Measure the input voltage to the steering position sensor.
NOTE
Be sure the battery is fully charged.
Connect a digital voltmeter [A] to the lead connector [B]
of the steering p osition sensor using the needle adapter
set [C].
Special Tool - Needle Adapter Set: 57001-1457
Connections to Steering Position Sensor Connector
Meter (+) R/W Terminal
Meter (–)
BK Terminal
Turn the i gnition switch ON.
Center the handlebar in the straight-ahead position.
Measure the input voltage.
Steering Position Sensor Input Voltage
Standard:
Battery Voltage
Turn the ignition switch OFF.
If the reading is good, inspect steering position sensor
output voltage.
If the reading is out of the standard, check the following.
Battery Voltage
20 A Main Fuse
Power Source Wiring (see Steering Position Sensor Cir-
cuit)