Filter
Top Products
11-6 PUMP AND IMPELLER
Pump and Impeller
Pump Removal
•
Turn the craft on its left side.
•
Disconnect the reverse cable ball joint at the rear end.
•
Unscrew the pump cover mounting bolts [A], and remove
the pump cover [B] with the reverse bracket [C].
•
Unscrew the grate mounting bolts [A] and remove the
grate [B].
•
Remove the joint bolts [A] and take off the steering cable
joint.
•
Loosen the clamps [B] on the inlet cooling hose, and pull
off the hoses [C].
•
Unscrew the pump mounting bolts [A].
•
Slide the pump [B] to the rear to disengage the drive shaft,
and remove it from the hull.
•
To remove the pump bracket, perform the following pro-
cedures.
○
Take out the pump bracket mounting bolts [A] and washer
in the hull.