Filter
Top Products
ELECTRICAL SYSTEM 14-31
Electric Starter S ystem
Reduction Gear Removal/Installation
•
Before removing the reduction gear, remove the magneto
flywheel (see Engine Bottom End chapter).
•
When installing the reduction gear, apply a molybdenum
disulfide grease [A] to both ends of its shaft.
Reduction Gear Inspection
•
Rotate the pinion gear [A] counterclockwise. The gear
must be rotated freely [B].
•
Rotate the pinion gear clockwise all the way. The pinion
gear will be advanced along the reduction gear shaft, and
stopped against the stopper [A].
•
Release the pinion gear. The pinion gear must return to
the initial position rapidly.
If the pinion gear does not function properly, replace it.
Electric Starter Circuit
1. Main Fuse 20 A
2. Ignition Switch