Filter
Top Products
13-16 H ULL/ENGINE HOOD
Rubber Parts
NOTE
○
The rubber parts on the watercraft are fastened in place
with various adhesives. To replace a rubber part, use a
cement in the following table, or an equivalent.
WARNING
Read all warnings and cautions on any solvents
and adhesives used. Many of these products are
flammable, may be harmful to the skin and eyes,
and may give off harmful vapors. Use these sol-
vents and adhesives only in a well-ventilated area
and never near an open flame.
For this Application Type
Mats
Synthetic Rubber
Engine Hood Gasket
Adhesive
Front Storage Comp
artment Cover
(P/N: 92104-3701)
Trim Seal
Detents
Cyanoacrylate Cement
Handlebar Grips
CAUTION
Be very careful that the part is positioned correctly
when you apply the cement. It may be impossible
to re
position the part.
WARNING
Do not get any cyanoacrylate cement in your eyes
or on
your skin. If you do get some in your eyes,
do not try to wash it out. Contact a physician im-
mediately! If you do get some on your fingers, do
not
touch any other part of your body; your fingers
will stick to anything they touch. Allow the cement
to cure and it will eventually wear off.
Rubber Parts Location
Engine Hood Gasket [A]
Re
ar Storage Tr im Seal [B]