8-12 ENGINE BOTTOM END
Magneto Flywheel
Magneto Flywheel Removal
•
Remove:
Engine (see Engine Removal/Installation chapter)
Crankshaft Sensor Cover (see Electrical System chap-
ter)
Coupling (see Coupling/Output Shaft Removal)
Magneto Cover (see Coupling/Output Shaft Removal)
○
Using the rotor puller [A], pull off the flywheel [B].
Special Tool - Rotor Puller: 57001-1623
Grip: 57001-1591 [C]
CAUTION
Do not hit the head of the rotor puller. A loss in rotor
magnetism may be caused.
Magneto Flywheel Installation
•
Using a high-flash points solvents, clean off any oil or dirt
that may be on the crankshaft taper, and in the tapered
hole in the magneto flywheel.
•
Install the O-ring [A] directly a s s hown.
○
This face [C] is magneto flywheel side.
•
Fit the woodruff key [B] securely in the crankshaft before
installing the magneto flywheel.
If the reduction gear [D] is removed, apply a molybdenum
disulfide grease to both ends of its shaft.
•
Install the reduction gear and the washer [E].