Kawasaki STX-15F Jet Ski User Manual


 
ENGINE B OTTOM E ND 8-9
Coupling
Using the rotor holder [A], remove the output shaft [B].
Special Tool - Rotor Holder: 57001-1544
Coupling/Output Shaft Installation
Apply molybdenum disulfide oil solution to the seating sur-
face of the output shaft.
Using the rotor holder [A], install the output shaft [B].
Special Tool - Rotor Holder: 57001-1544
Torque - Output Shaft: 245 N·m (25.0 kgf·m, 180 ft·lb)
Apply silicone sealant [A] to the crankcase halves mating
surfaces on the magneto cover.
Be sure to install the dowel pins [B].
Apply grease to the O-ring [A], and fit the O-ring onto the
groove of the magneto cover [B].
Install the magneto cover.
Be sure to install the washer [C] and the spring [D] into
the hole [E] of the bushing.
Torque - Magneto Cover Bolts: 2 0 N·m (2.0 kgf·m, 14 ft·lb)
Apply grease to the O-ring [A] and collar inside.
Install the collar [B] so that the chamfer side [C] faces
inward.