Filter
Top Products
STEERING 12-19
Reverse System
•
Turn the water craft on its left side and remove the pump
cover (see Pump/Impeller chapter).
CAUTION
Never lay the watercraft on the right side. Water in
the exhaust system may drain back into the engine,
causing serious damage.
•
Loosen the locknut [A] at the rear end of the shift cable,
and remove the ball joint [B] from the reverse bucket [C],
•
Disconnect the shift cable from the fitting at the middle of
the hull.
○
Unscrew the large nut (shift cable nut) in the hull with a
wrench.
○
Special tool, box wrench [A] is useful to remove the large
nut (shift cable nut).
Special Tool - Box Wrench: 57001-1451
•
Pull the cable from the cable detente in the engine com-
partment.
•
Slide off the snap ring [A], washer [B] and O-ring [C].
•
Pull out the shift cable toward the rear.
Shift Cable Installation
•
Slide a short piece of rubber or plastic tubing over the front
cable end to guide the cable through the hull.
•
Lubricate the outside of the new cable to ease cable in-
stallation.
•
Torque the shift cable nut.
Torque - Shift Cable Nut: 39 N·m (4.0 kgf·m, 29 ft·lb)
•
Apply a non-permanent locking agent to the cable bracket
mounting bolt.
•
Apply a water resistant grease to the joint ball at each end
of shift cable.
•
Adjust the shift cable (see Shift Cable Adjustment).
Shift Cable Inspection
•
Refer to Steering Cable/Shift Cable Inspection in the Pe-
riodic Maintenance chapter.
Shift Cable Lubrication
NOTE
○
The shift cable is sealed at each end and do not require
lubrication. If the seal is damaged, the cable must be
replaced.