Filter
Top Products
3-68 FUEL SYSTEM (DFI)
Throttle Lever, Cable and Case
•
Remove the throttle case (see Throttle Case Removal).
•
Slide the rubber boot out of the place.
•
Unscrew the throttle cable fitting nut.
•
Remove the upper end of the cable from the case.
○
Use a screw driver [A] to separate the cable tip [B] from
the throttle lever catch.
•
Remove the steering cover (see Steering Removal in
Steering chapter).
•
Unscrew the grommet mounting bolts [A] and pull out the
plate [B] and grommet [C].
•
Take the throttle cable [A] off the grommet [B].
•
Pull down the throttle cable.
Throttle Cable Installation
•
Lubricate the outside of the new cable with a penetrating
rust inhibitor to ease cable installation.
•
Slide the tip [A] of the cable lower end on the throttle pivot
arm [B].