Filter
Top Products
14-28 ELECTRICAL SYSTEM
Electric Starter System
Starter Motor Disassembly
•
Remove the starter motor (see Starter Relay Removal).
•
Take off the starter motor through bolts [A] and remove
both end covers [B] and pull the armature out of the yoke
[C].
•
Remove the terminal locknut [A] and terminal bolt [B], and
then remove the brush with the brush plate [C] from the
yoke.
Starter Motor Assembly
•
Apply a thin coat of grease to the oil seal [A].
•
Fit the toothed washer [B] into the end cover.
•
Install the plate cover [A] and the positive brush assembly
[B] in the yoke [C].
•
Tighten the terminal nut [D] securely.
•
Holding the spring ends [A] with suitable plates [B], put
the armature among the brushes.