FUEL SYSTEM (DFI) 3-67
Throttle Lever, Cable and Case
•
Tighten:
Torque - Throttle Case Mounting Screws: 3.9 N·m (0.40
kgf·m, 34 in·lb)
•
Swing the throttle lever so that the throttle valve is fully
open.
WARNING
Operation w ith an improperly assembled throttle
case could result in an unsafe riding condition.
•
Adjust the throttle cable (see Throttle Cable Adjustment).
Throttle Cable Removal
•
Remove the engine hood (see Hull/Engine Hood chap-
ter).
•
Remove the band [A] on the delivery pipe [B]
•
Disconnect the throttle cable from the body assy.
○
Slide out the rubber cap.
○
Unscrew the adjuster locknut [A] and slide the cable from
the bracket.
○
Slide the tip [A] of the cable lower end from the throttle
pivot arm.
•
Unscrew the mounting screws [A] and remove the han-
dlebar pad [B].
•
Take out the inner pad