Filter
Top Products
PUMP AND IMPELLER 11-7
Pump and Impeller
○
Take out the pump bracket mounting bolts [A].
○
Cut the sealant at the indicated area [A] in the figure and
remove the pump bracket [B].
Pump Installation
•
Strip off all the old sealant around the pump intake.
•
Liberally coat the outside edge of the pump bracket with
silicon sealant [A] to form a seal between the bracket and
the hull.
Sealant - Kawasaki Bond (Silicone Sealant): 56019-120
•
Install the pump bracket [A] to the hull.
○
Apply a non-permanent locking agent to the following
bolts and torque them.
Torque - Pump Bracket Mounting Bolts (2) [B]: 19 N·m (1.9
kgf·m, 14 ft·lb)
Pump Bracket Mounting Bolts (4) [C]: 9.8 N·m (1.0
kgf·m, 87 in·lb)
○
As for the pump bracket mounting bolts (2) in the hull, the
bolt heads should be wrapped in silicone sealant.