Filter
Top Products
STEERING 12-13
Steering
•
Remove the cotter pin [A] and steering s haft locknut [B].
•
Take out the holder [C].
•
Unscrew the steering holder mounting bolts [A], nuts, and
washers, and lift up the steering holder [B].
•
Take out the air intake duct mounting bolts [A] and remove
the air intake duct [B] from the steering holder [C].
•
Disconnect the switch case lead connector and pull the
leads [A] out of the hull.
•
Disconnect the pipe at the fuel vent hose upper end and
pull down the fuel vent hose [B].
•
Disconnect the throttle cable upper end at the throttle
case and pull down the throttle cable [C].
•
Remove the lock plate [A].
•
Take out the steering shaft nut [B] and pull down the steer-
ing shaft [C].
•
Remove the s teering holder.