Garmin G1000H Marine Radio User Manual


  Open as PDF
of 548
 
190-01255-00 Rev. B
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
122
AUDIO PANEL AND CNS
VFR CODE
The VFR codecanbe entered eithermanuallyor bypressingthe
XPDR
Softkey, then the
VFR
Softkey.
Whenthe
VFR
Softkeyispressed,thepre-programmedVFRcodeisautomaticallydisplayedinthecodeeld
oftheTransponderDataBox.Pressingthe
VFR
Softkey again restores the previous identification code.
Thepre-programmedVFRCodeissetatthefactoryto1200.IfaVFRcodechangeisrequired,contacta
Garmin-authorizedservicecenterforconguration.
Figure 4-38 VFR Code
VFR Code
IDENT FUNCTION
NOTE: In Standby Mode, the IDENT Softkey is inoperative.
Pressing the
IDENT
Softkey sends a distinct identity indication to Air Traffic Control (ATC). The indication
distinguishes the identing transponder from all the others on the air traffic controller’s screen. The
IDENT
Softkey appearson all levelsof transpondersoftkeys.  Whenthe
IDENT
Softkey is pressed, a green
IDNT
indicationisdisplayedinthemodeeldoftheTransponderDataBoxforadurationof18seconds.
After the
IDENT
Softkey is pressed while in Mode or Code Selection, the system reverts to the top-level
softkeys.
Press the IDENT
Softkey to Initiate
the ID Function
IDNT
Indication
Figure 4-39 IDENT Softkey and Indication
 previous next