Garmin G1000H Marine Radio User Manual


  Open as PDF
of 548
 
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
190-01255-00 Rev. B362
HAZARD AVOIDANCE
ATAwillbedisplayedforatleasteightseconds,evenifthecondition(s)thatinitiallytriggeredtheTAareno
longer present.
Figure 6-93 Traffic Annunciation (PFD)
Inset Map
Displays When
TA is Detected
Bearing Relative Altitude Distance (nm)
“One o’clock” through
“Twelve o’clock”
or “No Bearing”
“High”, “Low”, “Same Altitude” (if
within 200 feet of own altitude), or
“Altitude not available”
“Less than one mile”,
“One Mile” through “Ten Miles”, or
“More than ten miles”
Table 6-18 TA Descriptive Voice Announcements
AnauralTAannouncementmaybemutedwhileitisoccurringbypressingtheTA MUTEbuttononthe
collective.IfanewTAoccurs,anauralannouncementwillbeheard.
Ifanoptionalradaraltimeterindicatesownaircraftisbelow400’AGL,theGTS800automaticallymutesaural
trafcannunciations.Thismutingbehaviordoesnotoccuriftheradaraltimeterhasfailed.
SYSTEM TEST
NOTE: Traffic surveillance is not available during the system test. Use caution when performing a system
test during flight.
Thetrafcsystemprovidesasystemtestmodetoverifythesystemisoperatingnormally.Thetesttakesten
secondstocomplete.Whenthesystemtestisinitiated,atestpatternoftrafcsymbolsisdisplayedonthe
TrafcMapPage(Figure6-94).Theauralmessage“TAS System Test Passed” or “TAS System Test Failed” is
issuedwhenthetestiscomplete,andthetrafcsystemwillbeinStandbyMode.
Testing the traffic system:
1) Turn the large
FMS
Knob to select the Map Page Group.
2) Turn the small
FMS
Knob
to select the Traffic Map Page.
 previous next