Garmin G1000H Marine Radio User Manual


  Open as PDF
of 548
 
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
190-01255-00 Rev B64
FLIGHT INSTRUMENTS
GPS CDI SCALING
When GPS is the selected navigation source, the ight plan legs are sequenced automatically and
annunciationsappearontheHSIfortheightphase.Flightphaseannunciationsarenormallyshownin
magenta, but when cautionary conditions exist the color changes to yellow. If the current leg in the flight plan
isaheadingleg,‘HDGLEG’isannunciatedinmagentabeneaththeaircraftsymbol.
ThecurrentGPSCDIscalesettingisdisplayedas‘SystemCDI’ontheAUX-SystemSetupPageandthefull-
scaledeectionsettingmayalsobechanged(2.0nm,1.0nm,0.3nm,orAuto)fromthispage.Iftheselected
scaling is smaller than the automatic setting for enroute and terminal phases, the CDI is scaled accordingly
and the selected setting is be displayed rather than the flight phase annunciation.
Changing the selected GPS CDI setting:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the
large FMS
Knob to highlight ‘Selected’ in the ‘GPS CDI’ box.
4) Turn the small FMS Knob to highlight the desired setting and press the ENT Key.
5) To cancel the selection, press the FMS Knob or the CLR Key.
Figure 2-28 GPS CDI Settings
(AUX - System Setup Page)
Whensetto‘Auto’(default),theGPSCDIscaleautomaticallyadjuststothedesiredlimitsbaseduponthe
currentphaseofight(Figure2-29,Table2-1).
 previous next