Garmin G1000H Marine Radio User Manual


  Open as PDF
of 548
 
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
190-01255-00 Rev. B364
HAZARD AVOIDANCE
Switching from standby mode to operating mode:
On the Traffic Page, select the
OPERATE
Softkey
Or:
1) Press the MENU Key and turn the small
FMS
knob
to select ‘Operate Mode’.
2) Press the ENT Key. The system switches from Standby Mode to Operating Mode as necessary.
TRAFFIC MAP PAGE
TheTrafcMapPageshowssurroundingtrafcdatainrelationtotheaircraft’scurrentpositionandaltitude,
withoutbasemapclutter.Itistheprincipalpageforviewingtrafcinformation.Aircraftorientationisalways
headingupunlessthereisnovalidheading.MaprangeisadjustablewiththeRANGE Knobfrom2to12nm,
asindicatedbythemaprangerings.
The traffic mode and altitude display mode are annunciated in the upper left corner of the page.
Figure 6-95 Traffic Map Page
Altitude
Mode
Proximity Traffic,
900’ Above,
Level, Flight ID
Displayed
“No Bearing”
Traffic (Bearing
Undetermined),
Distance 4.0
nm, 500’ Above,
Climbing
Non-Threat Traffic,
2500’ Above,
Descending
Traffic
Advisory Off-
Scale, 400’
Below, Level
Traffic Display
Range Rings
Non-Threat
Traffic,
Altitude Not
Reported
Non-Threat
Traffic with
ADS-B
Directional
Information,
6000’ Above,
Level
Traffic Advisory with ADS-B Directional
Information, 500’ Below, Climbing
Altitude
Mode
Displaying traffic on the Traffic Map Page:
1) Turn the large
FMS
Knob to select the Map Page Group.
2) Turn the small
FMS
Knob
to select the Traffic Map Page.
3) Select the OPERATE Softkey to begin displaying traffic. OPERATING is displayed in the Traffic mode field.
4) Select the STANDBY Softkey to place the system in the Standby mode. STANDBY is displayed in the Traffic
mode field.
5) Turn the RANGE Knob clockwise to display a larger area or counter-clockwise to display a smaller area.
 previous next