Garmin G1000H Marine Radio User Manual


  Open as PDF
of 548
 
190-01255-00 Rev. B
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
363
HAZARD AVOIDANCE
3) Turn the Range knob to set the range to 2/6 nm to allow for the full test pattern to be displayed.
4) Select the TEST Softkey.
Or:
1) Press the MENU Key and turn the small
FMS
knob
to select ‘Test Mode’.
2) Press the ENT Key.
TA at 9 o’clock,
Distance 2.0
nm, 200’ Below,
Climbing
Non-Threat
Traffic at
11 o’clock,
Distance 3.6
nm, 1000’
Above, Level
Proximity
Traffic at
1 o’clock,
Distance
3.6 nm,
1000’ Below,
Descending
Operating
Mode
Test Mode
Annunciation
Figure 6-94 System Test in Progress with Test Pattern
OPERATION
Afterpower-up,thetrafcsystemisinStandbyMode.ThesystemmustbeinOperatingModefortrafcto
bedisplayedandforTAstobeissued.
Selecting theOPERATE Softkeyallows thesystem toswitch fromStandby Modeto OperatingMode as
necessary.SelectingtheSTANDBY SoftkeyforcestheunitintoStandbyMode.
Switching from operating mode to standby mode:
On the Traffic Page, select the
STANDBY
Softkey
Or:
1) Press the MENU Key and turn the small
FMS
knob
to select ‘Standby Mode’.
2) Press the ENT Key.
 previous next