Filter
Top Products
190-01255-00 Rev. B
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
34
SYSTEM OVERVIEW
BaRO tRansitiOn aleRt
See the Flight Instruments section for a discussion on setting the Baro Transition Alert.
aiRsPace aleRts
The Airspace Alerts Box allows the pilot to turn the controlled/special-use airspace message alerts on
or off. This does not affect the alerts listed on the Nearest Airspaces Page or the airspace boundaries
depicted on the MFD Navigation Map Page. It simply turns on/off the warning provided when the aircraft
is approaching or near an airspace.
Alerts for the following airspaces can be turned on/off in the Airspace Alerts Box:
•ClassB/TMA
•ClassC/TCA
•ClassD
•Restricted
•MOA(Military)
•Otherairspaces
An altitude buffer is also provided which “expands” the vertical range above or below an airspace. For
example, if the buffer is set at 500 feet, and the aircraft is more than 500 feet above/below an airspace, an
alert message is not generated, but if the aircraft is less than 500 feet above/below an airspace and projected
to enter it, the pilot is notified with an alert message. The default setting for the altitude buffer is 200
feet.
To change the altitude buffer distance setting:
1) While on the System Setup 1 Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the altitude buffer field in the Airspace Alerts Box.
3) Turn the FMS Knobs to enter an altitude buffer value and press the ENT Key.
To turn an airspace alert on or off:
1) While on the System Setup 1 Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the desired field in the Airspace Alerts Box.
3) Turn the small FMS Knob clockwise to turn the airspace alert ON or counterclockwise to turn the alert OFF.
aRRival aleRts
The Arrival Alert Box on the System Setup 1 Page allows arrival alerts to be turned on/off and the alert
trigger distance set. An arrival alert can be set to notify the pilot with a message upon reaching a user-
specified distance from the final destination (the direct-to waypoint or the last waypoint in a flight plan).
Once the set distance (up to 99.9 units) has been reached, an “Arrival at [waypoint]” message is displayed
in the PFD Navigation Status Box.
Enabling/disabling an arrival alert:
1) Turn the large FMS Knob to select the AUX Page group.
2) Turn the small FMS Knob to select System Setup.
3) If necessary, press the SETUP 1 Softkey to select the System Setup 1 Page.
4) Press the FMS Knob momentarily to activate the flashing cursor.