Garmin G1000H Marine Radio User Manual


  Open as PDF
of 548
 
190-01255-00 Rev. B
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
133
AUDIO PANEL AND CNS
VOICE RECOGNITION
VoiceRecognitionallowsthepilot(andoptionallycopilot)tocontroltheGMA350Husingspokencommands.
To activate Voice Recognition, push and hold the Push-To-Command (PTC) button while speaking a command.
WhenthePush-To-Commandbuttonisreleased,theGMA350Hwillrespond.
IfacommandiscorrectlyinterpretedbytheGMA350H,apositiveacknowlegementchimewillbeplayed,
and the pilot should verify that the correct button selection is indicated by the triangular annunciator lights.
Alternatively,somecommandswillbeindicatedbyavoiceresponsefromtheGMA350H.Ifthedesiredmodes
are not indicated by annunciator lights or a voice response, the pilot should repeat the command by using the
Push-To-Commandbutton,orbymanuallyusingthefrontpanelcontrolsoftheGMA350H.
IfacommandisincorrectlyinterpretedbytheGMA350H,anegativeacknowlegementtonewillbeplayed.
The pilot should repeat the command by using the Push-To-Command button, or by manually using the front
panelcontrolsoftheGMA350H.IntheeventofanyabnormalVoiceRecognitionoperation,atanytimethe
frontpanelcontrolsmaybeusedmanuallytocontroltheGMA350H.
The following table lists the available Voice Recognition commands, the associated actions, and the voice
response if applicable:
Control Spoken Command Action Confirmation of Action
COM
“COM one” Toggles COM1 Illuminate/Extinguish COM1 Annunciator
“MIC one”
Selects MIC1 Illuminate MIC1 Annunciator
“COM one MIC”
“COM two” Toggles COM2 Illuminate/Extinguish COM2 Annunciator
“MIC two”
Selects MIC2 Illuminate MIC2 Annunciator
“COM two MIC”
“COM three” Toggles COM3 Illuminate/Extinguish COM3 Annunciator
“MIC three”
Selects MIC3 Illuminate MIC3 Annunciator
“COM three MIC”
“Split COM” Selects split COM 1/2 Illuminate MIC1/MIC2 Annunciators
“Split COM 1 2” Selects split COM 1/2 Illuminate MIC1/MIC2 Annunciators
“Split COM 1 3” Selects split COM 1/3 Illuminate MIC1/MIC3 Annunciators
“Split COM 2 3” Selects split COM 2/3 Illuminate MIC2/MIC3 Annunciators
“Monitored COM mute” or
“Mute monitored COM”
Mutes monitored
COM on primary COM
reception
Voice Response:
“Monitor mute enabled”
“Disable monitored COM mute” or
“Monitored COM mute disable” or
“Disable mute monitored COM” or
“Mute monitored COM disable”
Disables monitored
COM mute on primary
COM reception
Voice Response:
“Monitor mute disabled”
NAV
“NAV one” Toggles NAV1 Illuminate/Extinguish NAV1 Annunciator
“NAV two” Toggles NAV2 Illuminate/Extinguish NAV2 Annunciator
AUX
“AUX” or
“Auxiliary”
Toggles AUX Illuminate/Extinguish AUX Annunciator
 previous next