Filter
Top Products
GuestWorks and DEFINITY ECS Release 9
Technician Handbook for Hospitality Installations
555-231-743
Issue 1
November 2000
Translations and Testing
84Miscellaneous Translations
Dial Plan (Switch)
Use the change dialplan command to administer the switch dial plan based on
the customer’s requirements. Unless otherwise instructed, set the Local Node
Number to 1. For more information about the Dial Plan feature, see the
DEFINITY ECS Administrator’s Guide
.
NOTE:
The PMS interface supports 3-, 4-, or 5-digit extensions, but be aware that
prefixed extensions do not send the entire number across the interface.
Only the assigned extension number is sent. Therefore, you should not use
prefixed extensions for numbers that are also going to use the Insert/Delete
Digit function (see “Hospitality Parameters” on page 208).
The add second-digit command is used when a first digit is defined as misc in
the Dial Plan. In this example, first digit 7 is used in several ways (70, 72x, 73x,
and 74x are feature access codes, and 71x, 78xx, and 79xx are extensions).
change dialplan Page 1 of 1
DIAL PLAN RECORD
Local Node Number: 1
ETA Node Number:
Uniform Dialing Plan: none ETA Routing Pattern:
FIRST DIGIT TABLE
First Length
Digit - 1 - - 2 - - 3 - - 4 - - 5 - - 6 -
1: extension
2: extension
3: extension
4: extension
5: extension
6: extension
7: misc
8: fac
9: fac
0: attd
*: fac
#: fac
add second-digit 7 Page 1 of 1
SECOND DIGIT TABLE FOR DIGIT 7
SECOND DIGIT TABLE
Digit Identification Number of Digit Identification Number of
Digits Digits
0: fac 2 5: 0
1: extension 3 6: 0
2: fac 3 7: 0
3: fac 3 8: extension 4
4: fac 3 9: extension 4