Filter
Top Products
GuestWorks and DEFINITY ECS Release 9
Technician Handbook for Hospitality Installations
555-231-743
Issue 1
November 2000
Translations and Testing
156Miscellaneous Translations
Trunk-to-Trunk Transfer (Switch)
Use the change system-parameters features command to enable Trunk-to-
Trunk Transfer only if it is requested by the customer. This feature is normally
disabled because of the possibility of toll fraud.
!
CAUTION:
If Trunk-to-Trunk Transfer is enabled, calls made to guest rooms can be
transferred outside of the hotel, and toll charges may be lost for some calls.
change system-parameters features Page 1 of 10
FEATURE-RELATED SYSTEM PARAMETERS
Self Station Display Enabled? y
Trunk-to-Trunk Transfer: none
Automatic Callback - No Answer Timeout Interval (rings): 3
Call Park Timeout Interval (minutes): 10
Off-Premises Tone Detect Timeout Interval (seconds): 20
AAR/ARS Dial Tone Required? y
Music/Tone on Hold: music Port: 01B1101
Music (or Silence) on Transferred Trunk Calls? no
DID/Tie/ISDN Intercept Treatment: attd
Messaging Service Adjunct (MSA) Connected? n
Internal Automatic Answer for Attendant Extended Calls? n
Automatic Circuit Assurance (ACA) Enabled? y
ACA Referral Calls: local
ACA Referral Destination: attd
ACA Short Holding Time Originating Extension: 3070
ACA Long Holding Time Originating Extension: 3070
Abbreviated Dial Programming by Assigned Lists? n
Auto Abbreviated/Delayed Transition Interval (rings): 2
Protocol for Caller ID Analog Terminals: Bellcore
Display Calling Number for Room to Room Caller ID Calls? n