Filter
Top Products
GuestWorks and DEFINITY ECS Release 9
Technician Handbook for Hospitality Installations
555-231-743
Issue 1
November 2000
Translations and Testing
142Miscellaneous Translations
Trunk Groups (Switch)
Use the add trunk-group command to assign each trunk group. For more
information on administering trunk groups, including CAMA 911 emergency
trunks, see the
DEFINITY ECS Administrator’s Guide
.
■ COR — Each trunk group must have a COR.
■ CDR Reports — Enter y for every trunk group that the customer wishes to
record. Usually, only outgoing trunk groups are recorded.
■ Dial Access — Enter n.
NOTE:
When a call accounting package is first installed, the set of extensions and
trunks administered on the switch is coordinated with the call accounting
vendor. If extensions and trunks are added at a later date, the call
accounting vendor must be notified so changes can be added to the call
accounting package.
add trunk-group 1 Page 1 of 11
TRUNK GROUP
Group Number: 1 Group Type: co CDR Reports: y
Group Name: Outside Call COR: 20 TN: 1 TAC: 710
Direction: two-way Outgoing Display? n
Dial Access? n Busy Threshold: 10 Night Service:
Queue Length: 0 Country: 1 Incoming Destination: attd
Comm Type: voice Auth Code? n Digit Absorption List:
Prefix-1? y Trunk Flash? n Toll Restricted? y
TRUNK PARAMETERS
Trunk Type: ground-start
Outgoing Dial Type: tone Cut-Through? n
Trunk Termination: rc Disconnect Timing(msec): 500
Auto Guard? n Call Still Held? n Sig Bit Inversion: none
Analog Loss Group: 6 Digital Loss Group: 11
Trunk Gain: high
Disconnect Supervision - In? y Out? n Cyclical Hunt? y
Answer Supervision Timeout: 10 Receive Answer Supervision? n