Filter
Top Products
Activate the System
7-8 September 1995 Issue 1
5. If all the red lights do not go off, reseat (unplug and reinsert) any
purple-labeled circuit packs displaying red lights.
!
CAUTION:
To avoid a disk crash, never reseat the DEFINITY AUDIX System
without first shutting it down. Shut down the DEFINITY AUDIX System
(and allow the disk to completely spin down) before unplugging the
DEFINITY AUDIX assembly. See Appendix C, "DEFINITY AUDIX
System Power Procedures" for the procedure for manually shutting
down and powering up DEFINITY AUDIX System.
!
CAUTION:
Before attempting to reseat white-labeled control circuit packs or the
purple-labeled tone detector/generator circuit pack (in the
single-carrier cabinet only), first power down the switch.
6. If the red lights still do not go off, read the note below and then refer to
DEFINITY Communications System Generic 1 and Generic 3i/s/vs
Maintenance
, 555-204-105, to resolve the trouble, if necessary.
NOTE:
Ignore the red alarm indication light on the TN767 or TN464 DS1
circuit pack until after the Digital Service Level 1 (DS1) circuit pack is
administered.
Table 7-1. Country Codes
Country Country Code Country Country Code
global 0 Spain 11
USA 1 France 12
Australia 2 Germany 13
Japan 3 Czechoslovakia 14
Italy 4 Russia 15
The Netherlands 5 Argentina 16
Singapore 6 Greece 17
Mexico 7 China 18
Belgium 8 Hong Kong 19
Saudi Arabia 9 Thailand 20
United Kingdom 10 Macedonia 21