Filter
Top Products
Activate the System
7-14 September 1995 Issue 1
NOTE:
The Set Date and Time Screen is displayed showing all data entered
in the previous steps followed by:
command:
Set System Maintenance Parameters
NOTE:
If you do not have a TN778 circuit pack, skip this procedure and proceed to
"Save Translations" on page 7-15.
1. Verify the terminal screen displays:
command:
2. Type change system-parameters maintenance and press
ENTER.
NOTE:
Verify the screen displays Maintenance-Related System Parameters
Screen (see Screen 7-4). The screen displays the default values
and the cursor is positioned on Product Identification: line.
Screen 7-4. Typical Display System-Parameters Maintenance Screen (Page 1)
display system-parameters maintenance Page 1 of 2
MAINTENANCE-RELATED SYSTEM PARAMETERS
OPERATIONS SUPPORT PARAMETERS
Product Identification: __________
OSS Telephone Number: __________
Alarm Origination Activated? n
Cleared Alarm Notification? n
Restart Notification? n
Test Remote Access Port? n
CPE Alarm Activation Level: none
Packet Bus Activated? n
Customer Access to INADS port? n
SCHEDULED MAINTENANCE
Start Time: 01
: 00
Daily Maintenance: dail y
Save Translation: dail y
Control Channel Interchange: no
System Clocks Interchange: no
SPE Interchange: no
EXP-LINK Interchange: no