Filter
Top Products
Activate the System
7-2 September 1995 Issue 1
Compatibility (EMC) wrist strap (comcode 900 698 226) when handling
circuit packs or other switch components.
Power Up Switch
To power up the switch, do the following:
Install Translation Flash-Memory Card
1. Verify the write switch on the white Translation Flash-Memory Card
(Translation Card) shipped with the system is positioned so the card can
be written. The write switch is shown in the correct position in Figure 7-1.
2. Install the Translation Card in the TN777B network control circuit pack.
Insert the card into the slot in the direction indicated by the arrow on the
card’s label as shown in Figure 7-1.
Figure Notes:
1. Insert card in direction of arrow into the slot.
2. Slot on TN777B circuit pack
3. Write switch positioned correctly
Figure 7-1. Write Switch on DEFINITY Memory Card
1
2
INSERT
Definity Memory Card
3