Filter
Top Products
Install the MSP-1 Power Supply
Issue 1 September 1995
9-35
Important Safety Instructions
The most careful attention has been devoted to safety standards in the
manufacture of this power supply. Safety is a major factor in the design of every
power supply. But, safety is
your
responsibility too.
Please read carefully the helpful tips listed below and on the next page. These
suggestions will enable you to take full advantage of this product. Then, retain
these tips for later use.
!
CAUTION:
When using this power supply, the following safety precautions should
always be followed to reduce the risk of fire, electric shock, and injury to
persons.
■ Read and understand all instructions.
■ Follow all warnings and instructions marked on this power supply.
■ This product can cause dangerous shock if immersed in water. To avoid
the possibility of electrical shock, do not use near water.
■ To reduce the risk of electric shock, do not disassemble this product.
There are no user serviceable parts inside.
■ This product should be operated only from the type of AC power source
indicated on the label. If you are not sure of the type of AC power being
provided, contact a qualified service person.
■ Do not allow anything to rest on the power cord. Do not locate this
product where the cord will be abused by persons walking on it.
■ Do not overload wall outlets and extension cords, as this can result in the
risk of line or electric shock.
■ Disconnect the cords on this product and refer servicing to qualified
service personnel under the following conditions:
— When the power supply cord or plug is damaged or frayed.
— If liquid has been spilled into the product.
— If the product has been exposed to rain or water.
— If the product does not operate normally by following the operating
instructions.
— If the product has been dropped or the housing has been
damaged.
— If the product exhibits a distinct change in performance.