Filter
Top Products
Issue 1 September 1995 B-1
B
Earthquake Protection Procedures
This appendix describes earthquake protection installation procedures to
perform if your site experiences earthquake activity.
Use the following procedures to install earthquake protection for your cabinets.
Install Floor Mounting to Attach
Cabinet to Floor
Attach your DEFINITY System Generic 3 (G3) cabinets to the floor by completing
the following steps:
1. Place the Front Mounting Angle at the location selected for the front of the
control cabinet.
2. Using the angle as the template, mark the location of the mounting bolts.
3. Drill two holes 1/2-inch (1.3 cm) in diameter and 1-1/2 (3.8 cm) inches
deep at the spot marked in Step 2.
4. Mount the Front Mounting Angle to the floor (see Figure B-1).