Filter
Top Products
Install and Connect the Cabinets
4-10 Issue 1 September 1995
Connect Frame Ground
Connect the 6 AWG frame ground cable to the cabinet frame by following these
steps:
1. Measure and cut a length of 6 AWG cable. Use the provided cable or
measure and cut a length of 6 AWG cable long enough to reach between
the GROUND CONNECTION terminal in the DC Battery Cabinet and the
GROUND DISCHARGE bar in the DC Power Cabinet.
2. Crimp terminal lugs on each end of the wire. Terminal lugs are furnished
as part of D-181895, Kit of Parts.
3. At DC power cabinet, connect wire to the GROUND DISCHARGE bar.
4. Route the wire through one of the holes in the side of the cabinet and
terminate it on the GROUND CONNECTION terminal in the DC Battery
Cabinet (see Figure 4-6).
Figure 4-6. Frame Ground Grounding
1
3
4
5
2
1. 6 AWG wire
2. Ground discharge bar
3. DC battery cabinet
4. Ground connection terminal
5. Power distribution unit
Figure Notes: