Filter
Top Products
Issue 1 September 1995 5-1
5
Install Telecommunications Cabling
This chapter describes how to install telecommunications cables and cross-
connect equipment.
The specific equipment being installed varies on what was ordered for your site.
Use the material presented in this chapter as an example.
Install the Cross-Connect Field
This section describes how to connect to the cross-connect field.
Typical Cross-Connect Field Using
110-Type Hardware
The cross-connect field is normally located directly behind the switch cabinet.
Figure 5-1 shows a typical cross-connect field installation using 110A-type
terminal blocks. Allow at least 3 feet (1 meter) between the back of cabinet and
the 110-type hardware.