Filter
Top Products
Test the System
8-18 Issue 1 September 1995
Screen 8-16. Example of System Status before Expansion Link is Set
3. Type set expansion-link xxxx where xxxx is the either one of the cabinet,
carrier, and port (see note on page 8-1) locations of the standby
expansion link.
4. Verify the screen displays:
Command successfully completed
Command:
5. Type status system all-cabinets and press
ENTER.
status system all-cabinets SPE B
SYSTEM STATUS CABINET 1
EMERGENCY SELECT SERVICE CABINET
TRANSFER SWITCH EXP-LINK STATE MODE TYPE
1A unavail 01A01-02A01 in standby MCC
1B auto-on 01B01-02B02 in active
-
-
Command successfully completed
Command: