Filter
Top Products
Log in to the System
September 1995 Issue 1
7-5
Commands
System commands are standard words and phrases instructing the switch to
perform a specific function. The commands are arranged in hierarchy of
keywords; that is, enter one command to take you to a different level. The
commands contain three parts: ACTION, OBJECT, and QUALIFIER.
■ ACTION is the first part of the command. When command: appears on the
screen. The ACTION specifies the operation you want to do. Examples of
permissible entries include add, duplicate, change, remove, display,
list, and save.
■ OBJECT is the second part of the command and specifies the particular
object you want to administer. Typical entries are hunt-group, coverage
path, and station.
■ QUALIFIER is the last part of the command. It is one or more words or
digits used to further identify or complete the OBJECT. For example,
hunt
group 15
or
station 3600
, where
15
and
3600
are qualifiers.
An example of the command line required to add a station with extension number
1234
is add station 1234. In this example, add is the ACTION, station is the
OBJECT, and 1234 is the QUALIFIER. In the command line, spaces are required
between the ACTION, OBJECT, and QUALIFIER.
To save time, enter enough letters for each part of the command to make it
unique. For example, if you want to enter the command change
system-parameters country-options, typing cha sys coun is acceptable.
However, typing the entire command will always work.
NOTE:
The craft login may not be allowed to perform some of the steps needed to
initialize the switch. If access is denied to some of these procedures,
contact your AT&T representative for assistance.
Getting Help
Use the HELP key for a list of options and the CANCEL key to back out of any
command.
Log in to the System
To log on the system, do the following:
1. Verify the screen displays:
Login:
2. Type craft and press
ENTER.