Filter
Top Products
Check Circuit Pack Configuration Again
Issue 1 September 1995
8-19
Screen 8-17. Example of System Status after Expansion Link is Set
6. Verify the MODEs of the expansion links have changed.
7. If any problems are indicated, check the Time Division Multiplexing (TDM)
cables and the inter-cabinet cables (ICC) in the associated Expansion
Port Network (EPN).
Check Circuit Pack Configuration
Again
Review the circuit packs contained in the system to ensure all circuit packs are
displayed on the screen.
1. Verify the screen displays:
command:
2. Type list configuration all and press
ENTER.
3. Verify all circuit packs installed in the system are listed in the reports.
Refer to the U.S. English book,
DEFINITY Communications System
Generic 1 and Generic 3i Maintenance
, 555-104-205, to resolve any
discrepancies.
status system all-cabinets SPE B
SYSTEM STATUS CABINET 1
EMERGENCY SELECT SERVICE CABINET
TRANSFER SWITCH EXP-LINK STATE MODE TYPE
1A auto-on 01A01-02A01 in active MCC
1B auto-on 01B01-02B02 in standby