Filter
Top Products
Activate the System
7-6 September 1995 Issue 1
3. Verify the screen displays:
password:
4. Type crftpw and press
ENTER. For security reasons, the password is not
displayed as it is typed. The system verifies a valid login and password
name were entered. If an invalid login or password name was entered, the
screen displays:
login incorrect:
In this case, repeat the procedure using the correct login and matching
password.
If the system recognizes the login and password name, the screen will
display the software version.
5. Verify the screen display is similar to:
Terminal Type (513, 715, 4410, 4425, VT220): [513]
6. Type the number of your management terminal and press
ENTER.
7. Verify the screen displays:
command:
Set Required Country Options
Certain country options need to be set to turn red failure indication lights off on
the circuit packs.
1. Verify the screen displays:
command:
2. Type change system-parameters country options and press
ENTER.
The following screen is displayed. The cursor is set on Companding
Mode line.