Filter
Top Products
Install Generic 3 Management Terminal
6-6 Issue 1 September 1995
Set Up G3 Management Terminal
(G3-MT)
Use the following procedures to set up the 715 Management Terminal options:
NOTE:
These procedures may change as the model of 715 Management Terminal
(G3-MT) shipped with DEFINITY System Generic 3 changes. Consult the
documentation shipped with the terminal for set up instructions.
1. Hold down the
CTRL key while pressing F1 and verify the terminal setup
screen is shown.
Function keys (F1, etc.) are located at the top of the keyboard of the
terminal. Lighted rectangles (windows) appear at the bottom of the screen
and correspond to the function keys across the top of the keyboard.
2. Press
F7 to make sure the default values are set.
3. Using the up/down arrow keys on the keypad, position the cursor at the
Keyboard Options (per window) field and press
RETURN.
4. Using the up/down arrow keys on the keypad, position the cursor at the
Enter Key field. Then under Primary/Window 1 press the
ESC key,
then hold down the
SHIFT key and type S and then B. This will enter
escapeSB in this field.
5. Press F5-SAVE to save the changes then press F1 SETUP MENU and
exit the Setup Menu screen.
Table 6-1. Required Settings for 715 Management Terminal
to Communicate with Switch
Terminal Option Value
Font Size Large (default)
Autowrap Off (default)
Baud Rate 9600 (default)
Stop Bit 1 (default)
Data Bits 7 (default)
Parity Space (default)
Check Parity Yes (default)
Transmission Flow Control X on, X off (default)
Enter Key escapeSB (must be set)