Filter
Top Products
Install Telecommunications Cabling
5-4 Issue 1 September 1995
■ Route the cable from the cabinet to the wall. Place the cable beside one
of the rows of columns in the cable slack manager (see following note).
NOTE:
Retainers mounted on the columns keep the cable from protruding
above the top of the base of the cable slack manager.
■ Determine the length of the cable required to reach from the cable slack
manager to the assigned connecting/terminal block.
■ The cable must be supported on the wall.
■ Cable slack is stored by coiling the cable around the columns in the
cable slack manager. The first run should always go across the full length
of the five columns in the cable slack manager.
■ Connect the cable to the assigned connecting/terminal block.