Filter
Top Products
Connect Battery Leads
Issue 1 September 1995
4-5
Connect Battery Leads
To prevent the batteries from discharging, the control cabinet is shipped with
the battery lead disconnected. To connect the batteries, perform the following:
At cabinet(s):
1. Ensure the circuit breakers on each cabinet are OFF.
Each cabinet has its own power supply and the circuit breaker is located
on the rear of each power supply. See Figure 4-3.
2. Connect the battery lead:
See Figure 4-3. The battery is near the top of the carrier toward the front-
right. The battery leads should be immediately next to the battery, on the
left side, and accessible from the front of the cabinet.
Figure Notes:
1. Battery
2. Circuit Breaker
3. Ground block
Figure 4-3. Single Carrier Cabinet Control Cabinet
Battery Location, Right Side View
1
2
3