Filter
Top Products
September 1995 Issue 1 H-1
H
Option Switch Settings
Some of the interface units used between the single-carrier and multi-carrier
cabinets and other types of equipment require specific option switch settings for
each application. This section lists the option switch settings required for
modular processor data modules, modular trunk data modules, modems,
printers, etc., when these units are used with the switch. Only the option switch
settings for use with single-carrier or multi-carrier cabinets are shown. Refer to
the User Guide on each type of equipment for information on how to locate and
set the option switches.
Distributed Communications System
(DCS) Option Settings for G3i Systems
The distributed communications system (DCS) is sometimes connected to the
switch through the processor interface circuit pack. The first circuit on the
processor interface can be connected directly to the distributed communications
system (DCS) through the PROCESSOR INTERFACE connector on the rear of
the control carrier. Any of the remaining three circuits on the processor interface
used to support the distributed communications system (DCS) must be