Filter
Top Products
Overview and Roadmap
1-6 Issue 1 September 1995
Install and Wire Telephones and Other
Equipment
Complete this task by following the instructions provided in Chapter 9.
NOTE:
For easier reference, installation steps and test steps are grouped in
separate chapters. It may be better to install each hardware component,
administer it, and then test it before going on to install another component.
As an example, install the Attendant Console using the procedures in
Chapter 9, "Install and Wire Telephones and Other Equipment", administer
it using the procedures in "Administer the DEFINITY System According to
Customer Requirements" on page 1-7, and test it using the procedures in
Chapter 10, "Test Telephones and Other Equipment".
1. Make and label wiring cross connections for this customer, using
provisioning plan as directed in Step 7 of Chapter 2, "Plan and Prepare
the Site".
2. Install and label equipment.
3. Install the attendant consoles.
4. Install the telephones.
5. Install the trunks.
6. Install the interface for the remote management terminal (known as
INADS).
7. Install the emergency transfer units and associated telephones.
8. Install external ringing.
9. Install queue warning indicator.
10. Install auxiliary power.
11. Install Basic Rate Interface (BRI) telephone, Basic Rate Interface (BRI)
terminating resistor, multipoint adapter, and power adapter.
12. Install auxilliary equipment
13. Install the Processor Data Module (PDM).
14. Install the Call Management System (CMS) interface.
15. Install Property Management System (PMS).
16. Install any customer-provided terminals using Asynchronous Data Units
(ADUs).
17. Install Station Message Detail Recording (SMDR)/Call Detail Recording
Unit (CDRU) interface.