Filter
Top Products
Test Basic Rate Interface (BRI)
Issue 1 September 1995
10-15
3. Remote access personnel enters test inads-link command, terminates
login, and disconnects.
4. Remote access personnel then check the appropriate trouble ticket. The
trouble ticket should show ‘‘INADS,n,MINOR’’ in the description field to
indicate a minor off-board alarm was reported to the remote access
personnel. There may be additional text in the description field if other
resolved alarms were reported.
5. Remote access personnel make second call and login to system and
checks the error log to verify no problems. See
DEFINITY Communications
System Generic 1 and Generic 3i/s/vs Maintenance
, 555-204-105, or
DEFINITY Communications System Generic 3r Maintenance
,
555-230-105, for error log and error code information.
6. Remote access personnel terminate login and disconnects.
Procedure—Local Test
1. Log in and enter test inads-link command.
2. Request remote access personnel to verify a trouble ticket was created.
3. Check error log to verify no problems.
4. Log off the system.
Test Basic Rate Interface (BRI)
Description
Check for normal voice telephone function (dial tone, ability to make and receive
calls). Check for the correct Service Profile Identifier (SPID) on a display
Telephone and the G3 Management Terminal (G3-MT).
Procedure—Dial Tone
1. Lift handset of Basic Rate Interface (BRI) telephone and listen for dial
tone.
Procedure—Make and Receive Calls
1. Select a working telephone with display and dial that telephone’s
extension number from the Basic Rate Interface (BRI) test telephone. The
called telephone rings.
2. At the called telephone, pick up the receiver. Conversation must be
satisfactory.