Filter
Top Products
Test Telephones and Other Equipment
10-10 Issue 1 September 1995
6. At the test telephone, hang up the receiver.
7. On the attendant console, press Night key.
8. Verify Night lamp goes dark.
Procedure—Ringing Device Not Installed
1. Connect a spare 2500-type telephone to the information outlet indicated
on the console parameters screen.
2. On the attendant console, press Night key.
3. Verify Night lamp lights.
4. Select a working telephone as the test telephone.
5. At the test telephone, pick up the receiver, dial a trunk access code and
the listed directory number for the attendant console.
6. Verify ringing is heard on the spare telephone.
7. At the test telephone, hang up the receiver.
8. Disconnect the spare telephone from the information outlet.
9. Press the Night key on the attendant console.
10. Verify the Night lamp goes off.
11. Notify the customer that installation is complete and the external ringing
device can be installed.
Test Queue Warning Indicator
Description
Make a test call to an extension associated with a Uniform Call Distribution (UCD)
or Direct Department Calling (DDC) group, and verify the queue warning
indicator lamp lights. If the queue warning indicator has not yet been installed by
customer, connect a spare telephone to the information outlet reserved for queue
warning indicator and make a test call.
Procedure—Queue Warning Indicator Installed
1. Administer Queue Warning Indicator number to 0 on Hunt Group Screen.
Record old number.
2. Make sure all telephones in the group are disconnected or are “busy.”
3. Select a working telephone as the test telephone.