Filter
Top Products
Station Message Detail Recording (SMDR) Interface
Option Settings
September 1995 Issue 1
H-35
■ When the function to be changed is reached, press the On Line button.
This activates the menu (available option settings) for the function. Use the
Line Feed and Form Feed buttons to step through the options for the
function.
■ When a desired option is located, press the Print Quality button.
■ Each time an option is set, the function and setting is printed.
1. Repeat Step 3 for each option to be set.
2. When the options are set, depress Print Quality button. The printer is now
in the normal print mode.
Station Message Detail Recording
(SMDR) Interface Option Settings
The interface between the G1 switch and station message detail recording
equipment may be one of the following:
■ Modular processor data module (MPDM) or modular trunk data module
(MTDM)
—The recommended option settings are shown in the following
table.
■ 212-type modem—The recommended option settings for the 212-type
modem are shown in Table H-25.
■ TN726 Data Line circuit pack and an Asynchronous Data Unit — modular
processor data module (MPDM), modular trunk data modules (MTDM), or
212-type modems are not required.
■ Connected directly to the DATA COMMUNICATIONS EQUIPMENT
connector (Electronic Industries Association (EIA) Port) located on the
back of the Control Carrier
—modular processor data modules (MPDM),
modular trunk data modules MTDM), or 212 modems are not required.
■ 7400A—The recommended option settings for the 7400A Data Module
are given in this chapter under the heading: "7400A Option Settings" on
page H-19
.
94 STOP BIT 01 1
95 PARITY 01 NONE
96 PBS 04 1200
Table H-23. 572 Printer used as System Printer
572 Printer Option Settings
Function Function Menu Menu
Number Name Number Status