Filter
Top Products
100
Frequency setting by external terminals
REMARKS
During Jog operation or PID control operation, the remote setting function is invalid.
⋅ Even when the remotely-set
frequency is cleared by turning
on the RL (clear) signal after
turn OFF (ON) of both the RH
and RM signals, the inverter
operates at the remotely-set
frequency stored in the last
operation if power is reapplied
before one minute has elapsed
since turn OFF (ON) of both the
RH and RM signals
⋅ When the remotely-set
frequency is cleared by turning
on the RL (clear) signal after
turn OFF (ON) of both the RH
and RM signals, the inverter
operates at the frequency in the
remotely-set frequency cleared
state if power is reapplied after
one minute has elapsed since
turn OFF (ON) of both the RH
and RM signals.
CAUTION
When selecting this function, re-set the maximum frequency according to the machine.
♦ Parameters referred to ♦
Pr. 1 Maximum frequency, Pr. 18 High speed maximum frequency Refer to page 87
Pr. 7 Acceleration time, Pr. 8 Deceleration time, Pr. 44 Second acceleration/deceleration time, Pr. 45 Second deceleration time
. Refer to page 101
Pr. 28 Multi-speed input compensation selection Refer to page 97
Pr. 178 to Pr. 189 (input terminal function selection) Refer to page 122
Setting frequency is "0"
Clear (RL)
Acceleration (RH)
ON
Power supply
ON
ON
ON
ON
ON
Within 1 minute
Remotely-set frequency stored last time
Time
Remotely-set frequency stored last time
Deceleration (RM)
OFF
Output frequency
(Hz)
Forward rotation
(STF)
Clear (RL)
Acceleration (RH)
Forward rotation (STF)
ON
Power supply
ON
ON
ON
ON
ON
Time
Remotely-set frequency stored last time
One minute
Deceleration (RM)
OFF
Output frequency
(Hz)
More than
one minute
Operation is performed at the set
frequency 0Hz.