Filter
Top Products
Product Preview DS21Q55
134 of 248 012103
Please contact telecom.support@dalsemi.com or search http://www.maxim-ic.com for updated
information.
22.2 HDLC Configuration
Basic configuration of the HDLC controllers is accomplished via the HxTC and HxRC registers.
Operating features such as CRC generation, zero stuffer, transmit and receive HDLC mapping options,
and idle flags are selected here. Also, the HDLC controllers are reset via these registers.
Register Name: H1TC, H2TC
Register Description: HDLC #1 Transmit Control, HDLC #2 Transmit Control
Register Address: 90h, A0h
Bit # 7 6 5 4 3 2 1 0
Name NOFS TEOML THR THMS TFS TEOM TZSD TCRCD
Default 0 0 0 0 0 0 0 0
Bit 0/Transmit CRC Defeat (TCRCD). A 2-byte CRC code is automatically appended to the outbound message. This bit can
be used to disable the CRC function.
0 = enable CRC generation (normal operation)
1 = disable CRC generation
Bit 1/Transmit Zero Stuffer Defeat (TZSD). The zero stuffer function automatically inserts a zero in the message field
(between the flags) after five consecutive ones to prevent the emulation of a flag or abort sequence by the data pattern. The
receiver automatically removes (de-stuffs) any zero after five ones in the message field.
0 = enable the zero stuffer (normal operation)
1 = disable the zero stuffer
Bit 2/Transmit End of Message (TEOM). Should be set to a one just before the last data byte of an HDLC packet is written
into the transmit FIFO at HxTF. If not disabled via TCRCD, the transmitter will automatically append a 2-byte CRC code to
the end of the message.
Bit 3/Transmit Flag/Idle Select (TFS). This bit selects the inter-message fill character after the closing and before the
opening flags (7Eh).
0 = 7Eh
1 = FFh
Bit 4/Transmit HDLC Mapping Select (THMS).
0 = transmit HDLC assigned to channels
1 = transmit HDLC assigned to FDL (T1 mode), Sa Bits (E1 mode)
Bit 5/Transmit HDLC Reset (THR). Will reset the transmit HDLC controller and flush the transmit FIFO. An abort followed
by 7Eh or FFh flags/idle will be transmitted until a new packet is initiated by writing new data into the FIFO. Must be cleared
and set again for a subsequent reset.
0 = normal operation
1 = reset transmit HDLC controller and flush the transmit FIFO
Bit 6/Transmit End of Message and Loop (TEOML). To loop on a message, should be set to a one just before the last data
byte of an HDLC packet is written into the transmit FIFO. The message will repeat until the user clears this bit or a new
message is written to the transmit FIFO. If the host clears the bit, the looping message will complete then flags will be
transmitted until new message is written to the FIFO. If the host terminates the loop by writing a new message to the FIFO the
loop will terminate, one or two flags will be transmitted and the new message will start. If not disabled via TCRCD, the
transmitter will automatically append a 2-byte CRC code to the end of all messages. This is useful for transmitting consecutive
SS7 FISUs without host intervention.
Bit 7/Number Of Flags Select (NOFS).
0 = send one flag between consecutive messages
1 = send two flags between consecutive messages