Polycom 1500/1800/2000/4000 Life Jacket User Manual


  Open as PDF
of 1101
 
System Configuration Flags
Polycom®, Inc. 779
BLOCK_CONTENT_LEGACY_FOR
_LYNC
This flag is used to control the system behavior in an environment where
some Lync clients use the Polycom CCS plug-in and some do not.
When set to NO (default), Content is sent to all Lync clients over the video
channel, including those with the plug-in installed, even when the Send
Content to Legacy Endpoints is disabled. Other, non-Lync legacy endpoints
will not be affected by this flag and will receive content according to the
Send Content to Legacy Endpoints settings in the conference Profile.
When set to YES, Content is not sent to Lync clients over the video channel
including those with the Polycom CCS plug-in installed, even when the
Send Content to Legacy Endpoints is enabled. Other, non-Lync legacy
endpoints will not be affected by this flag and will receive content according
to the Send Content to Legacy Endpoints settings in the conference Profile.
BONDING_DIALING_METHOD When set to:
SEQUENTIAL
The MCU initiates channel connections sequentially until it reaches the
number of channels defined by the
BONDING_NUM_CHANNELS_IN_GROUP flag.
When a channel is connected, dialing begins for the next channel in the
group.
BY_TIMERS
The MCU initiates channel connections sequentially using the values of
the BONDING_CHANNEL _DELAY and BONDING_GROUP_DELAY
flags.
The first group of channels is dialed, using the
BONDING_CHANNEL_DELAY between dialing attempts for each
channel in the group.
The Collaboration Server then implements the
BONDING_GROUP_DELAY, before dialing the first channel of the next
group.
Default: SEQUENTIAL
BONDING_GROUP_DELAY
(ISDN)
When connecting several bonding groups, this is the delay (number of
1/100 seconds) preceding the first dialing attempt to connect the next
bonding group.
Default: 500
BONDING_NUM_CHANNELS_IN_
GROUP
(ISDN)
The number of channels in the bonding group to be connected before
dialing the next sequential channel.
Default: 50
BURN_BIOS Although not recommended
, setting this flag’s value to NO will prevent
BIOS upgrade.
Default: YES.
CAC_ENABLE When set to YES, enables the Call Admission Control implementation in the
Collaboration Server.
Default: NO (CAC is disabled)
Manually Added, Modified, Deleted System Flags
Flag Description