Filter
Top Products
System Configuration Flags
Polycom®, Inc. 789
IGNORE_AIM Audio Indicate Muted (AIM) is Relevant to H.323 endpoints. When an
endpoint mutes its microphone, it does not necessarily mute its entire audio
stream. This allows sharing of Content that includes audio while
microphones are muted.
When set to:
NO - When the AIM signal is received, the participant is muted and a mute
icon is displayed in the RMX Web Client / RMX Manager.
YES - When the AIM signal is received, the participant is not muted and a
mute icon is not displayed in the RMX Web Client / RMX Manager.
Range: YES, NO
Default: NO
IP_LINK_ENVIRONMENT In H.239-enabled MIH Cascading, when MGC is on level 1, setting this flag
to YES will adjust the line rate of HD Video Switching conferences run on
the RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 from
1920Kbps to 18432, 100bits/sec to match the actual rate of the IP Only HD
Video Switching conference running on the MGC.
Note: If the flag MIX_LINK_ENVIRONMENT is set to NO, the
IP_ENVIRONMENT_LINK flag must be set to YES.
IP_RESPONSE_ECHO When the System Flag value is YES, the Collaboration Server will respond
to ping (IPv4) and ping6 (IPv6) commands. When set to NO, the
Collaboration Server will not respond to ping and ping6 commands.
IPV6_AUTO_ADDRESS_CONFIGU
RATION_METHOD
SLAAC (Stateless Address Auto Configuration) and DHCPv6 related
system behavior is controlled by setting this flag’s value as required.
Range: AUTO / SLAAC
AUTO—(default) Use DHCPv6 first in case of failure use SLAAC.
SLAAC—Use SLAAC only.
ITP_CERTIFICATION When set to NO (default), this flag disables the telepresence features in the
Conference Profile.
Set the flag to YES to enable the telepresence features in the Conference
Profile (provided that the appropriate License is installed).
LAN_REDUNDANCY Enables Local Area Network port redundancy on RealPresence
Collaboration Server (RMX) 2000/4000 RTM LAN Card and RealPresence
Collaboration Server (RMX) 1500 LAN ports on the RTM IP 1500.
Range: YES / NO
Default: NO
Note: If the flag value is set to YES and either of the LAN connections
(LAN1 or LAN2) experiences a problem, an active alarm is raised stating
that there is no LAN connection, specifying both the card and port number.
Manually Added, Modified, Deleted System Flags
Flag Description