System Configuration Flags
Polycom®, Inc. 796
REMOVE_H323_HIGH_PROFILE_
CAP_TO_NON_POLYCOM_VEND
OR
Used to disable High Profile protocol. Use of Polycom’s proprietary
protocol, High Profile, may result in interoperability issues when used with
other vendors’ endpoints.
Possible values: YES / NO
Default: NO
REMOVE_H323_HIGH_QUALITY_
AUDIO_CAP_TO_NON_POLYCOM
_VENDOR
Used to disable the following Audio Codecs:
• G231
• G7221C
• G7221
• G719
• Siren22
• Siren14
Possible values: YES / NO
Default: NO
REMOVE_H323_LPR_CAP_TO_N
ON_POLYCOM_VENDOR
Used to disable H.323 LPR protocol. Use of Polycom’s proprietary protocol,
H.323 LPR, may result in interoperability issues when used with other
vendors’ endpoints.
Possible values: YES / NO
Default: NO
REMOVE_IP_IF_NUMBER_EXIST
S
Between the time a conference is scheduled and when it becomes active,
the IP of an endpoint may change, especially in an environment that uses
DHCP. This flag determines if the E.164 number is to be substituted for the
IP address in the dial string.
Range: YES / NO
Default: YES - The IP address will be substituted with the E.164 number.
RFC2833_DTMF Controls the receipt of in-band and out-of-band DTMF Codes. When set to:
• YES The RMX will receive DTMF Codes sent in-band.
• NO The RMX receive DTMF Codes sent out-of-band.
The RMX always sends DTMF Codes in-band (as part of the Audio Media
stream).
Range: YES/NO
Default YES
RMX_MANAGEMENT_SECURITY_
PROTOCOL
Enter the protocol to be used for secure communications.
Default: TLSV1_SSLV3 (both).
Default for U.S. Federal licenses: TLSV1.
RTCP_FIR_ENABLE When set to YES, the Full Intra Request (FIR) is sent as INFO (and not
RTCP).
Default = YES
RTCP_FLOW_CONTROL_TMMBR
_ENABLE
Enables/disables the SIP RTCP flow control parameter.
Default: YES
Manually Added, Modified, Deleted System Flags
Flag Description