Filter
Top Products
System Configuration Flags
Polycom®, Inc. 787
FORCE_AUDIO_CODEC_FOR_MS
_SINGLE_CORE
This flag is used to force the use of a specific Audio algorithm when a
Microsoft Office Communicator R2 or Lync Client is hosted on a workstation
with a single core processor. The flag value overrides the default audio
algorithm selection (G.722.1) that may cause audio quality problems when
G.722.1 is used by Microsoft Clients running on single processor
workstations.
This flag can be set to:
• AUTO – No forcing occurs and the Collaboration Server negotiates a full
set of Audio algorithm during capabilities exchange.
• G711A/U or G722 – Set this flag value according to the hosting
workstation capabilities. If the Collaboration Server detects single core
host during capabilities exchange it will assign a G.711 or G.722 Audio
algorithm according to the flag value.
Possible values: AUTO, G711A, G711U, G722
Default: G711A
FORCE_ENCRYPTION_FOR_UND
EFINED_PARTICIPANT_IN_WHEN
_AVAILABLE_MODE
When set to YES, Undefined participants must connect encrypted,
otherwise they are disconnected.
When set to NO (default) and the conference Encryption in the Profile is set
to Encrypt When Possible, both Encrypted and Non-encrypted Undefined
participants can connect to the same conferences, where encryption is the
preferred setting.
Default: NO
FORCE_G711A Setting this flag forces the use of the G711A Audio Codec.
Possible values: YES / NO
Default: NO
FORCE_RESOLUTION Use this flag to specify IP (H.323 and SIP) endpoint types that cannot
receive wide screen resolution and that were not automatically identified as
such by the Collaboration Server.
Possible values are endpoint types, each type followed by a semicolon. For
example, when disabling Wide screen resolution in an HDX endpoint enter
the following string: HDX;
Note: Use this flag when the flag SEND_WIDE_RES_TO_IP is set to YES.
FORCE_STATIC_MB_ENCODING This flag supports Tandberg MXP mode of sending and receiving video by
IP endpoint in HD 720p resolution and Video Quality set to Motion. This
mode is not supported for ISDN endpoints.
Default value: Tandberg MXP.
To disable this flag, enter NONE.
G728_IP Enables or disables declaration of G.728 Audio Algorithm capabilities in IP
calls.
Range: YES / NO
Default: NO
Manually Added, Modified, Deleted System Flags
Flag Description