Filter
Top Products
Installation and Test for CallVisor ASAI
14-2 Issue 7 May 1998
■ Expansion Interface Circuit Pack — For new multiple-port network systems
or upgrades. [If you have the older TN776 circuit pack, it must be replaced
with a TN570 circuit pack or later, which permits CallVisor ASAI to
terminate on an Expansion Port Network (EPN)].
■ MultiQuest trunk for Flexible Billing
Software Installation
In addition to the CallVisor ASAI and the DEFINITY ECS basic software, the
following software might be needed for your specific CallVisor ASAI installation.
Refer to the
DEFINITY Enterprise Server Installation and Test for Single-Carrier
Cabinets
, 555-230-894,
or DEFINITY Enterprise Communications Server
Installation and Test for Multi-Carrier Cabinets
, 555-230-112, for more information.
■ Automatic Call Distribution (ACD) Software — For ACD configurations
■ Automatic Route Selection (ARS) Software — For ISDN-PRI call routing
■ ISDN-PRI Software — For ISDN-PRI trunks
■ Vectoring Basic Software — For call vectoring applications and ASAI
adjunct routing
■ Vectoring Prompting Software — For integrated call prompting applications
■ Vectoring (ANI II Digits Routing)
■ Vectoring (G3V4 enhanced)
■ Vectoring (G3V4 advanced routing)
■ EAS Agent Skills
CallVisor ASAI Link Administration
The CallVisor ASAI software must be installed in your system before an ASAI link
can be administered and activated. Up to eight ASAI links can be administered at
the same time to the same or different adjunct processors using either BRI and/ or
Ethernet transport.
To administer an ASAI link, use the add station command and set the link type to
ASAI. Fill out the remainder of the form as appropriate for your ASAI host.
CallVisor ASAI links do not support Management Information Messages (MIMs).
Figure 14-1 shows a sample completed Add Station form.